Enter/Exit Programming Mode 1D Symbology Programming
352 Magellan™ 9300i / 9400i Scanners
Code 39 Check Character Calculation
Enables/disables calculation and verification of an optional Code 39 check
character. When disabled, any check character in label is treated as a data char
-
acter.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
If check calculation is disabled, the risk is increased that a
misread can occur.
Code 39 Check Character Calculation = Disable
Code 39 Check Character Calculation = Enable
DEFAULT
To Next Page
Loading...
