Product Reference Guide 469
Appendix E
Host Commands
Accepting Commands from an RS-232 Scanner Host
The scanner responds to the following RS-232 commands:
If one of the above commands is received, the scanner will perform the steps
indicated for the command. Host commands for other interfaces are also avail
-
able. Contact Tech Support for more details.
COMMAND ASCII HEX COMMENT
Enable Scanner
E 0x45
Disable Scanner
D 0x44
Reset Scanner
R 0x52
Not On File Indication
F 0x46 Long series of beeps
Beep Good Read Tone
B 0x42 Beeps if Good Read Beep is enabled
Force Good Read
Tone
0x01 Beeps regardless of beep setting
Bel
0x07 Force Good Read Tone
Identification request
i 0x69
Returns long response
a
a. Call Tech Support for information.
Health request
h 0x68
Returns long response
a
Status request
s 0x73
Returns long response
a