Enter/Exit Programming Mode Interface Related Features
224 Magellan™ 9300i / 9400i Scanners
RS-232 Number of Stop Bits
Specifies number of stop bits required for sending and receiving data.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code below representing the desired Stop Bit setting. You’ll
need to cover any unused barc odes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
RS-232 Number of Stop Bits = 1
RS-232 Number of Stop Bits = 2
DEFAULT
To Next Page
Loading...
