Datalogic Magellan 9300i - Double Read Timeout

Enter/Exit Programming Mode General Scanner and Scale Features
128 Magellan™ 9300i / 9400i Scanners
2D Double Read Timeout
The 2D Double Read Timeout feature specifies the minimum allowable time which must
pass before reading the same 2D label again (e.g. two identical items in succession).
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
If the incidence of multiple reads is not acceptable, increase the
Timeout setting to a higher value.
2D Double Read Timeout = 300ms
2D Double Read Timeout = 400ms
2D Double Read Timeout = 600ms
2D Double Read Timeout = 700ms
2D Double Read Timeout = 800ms
03DF1E(CR)
03DF28(CR)
03DF3C(CR)
DEFAULT
03DF46(CR)
03DF50(CR)