Enter/Exit Programming Mode Interface Related Features
256 Magellan™ 9300i / 9400i Scanners
Keyboard Wedge No Keyboard Support
Enables the scanner to perform host communications normally performed by an
attached keyboard.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Keyboard Wedge No Keyboard Support = Disable
Keyboard Wedge No Keyboard Support = Enable
DEFAULT
To Next Page
Loading...
