Datalogic Magellan 9300i - GS1 QR Code Enable

Enter/Exit Programming Mode 2D Symbology Programming
440 Magellan™ 9300i / 9400i Scanners
GS1 QR Code Enable
This feature controls the ability of the scanner to decode GS1 QR Code labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
GS1 QR Code = Disable
GS1 QR Code = Enable
DEFAULT
047500(CR)
047501(CR)