Enter/Exit Programming Mode 2D Symbology Programming
428 Magellan™ 9300i / 9400i Scanners
PDF 417
PDF 417 Enable
Enablesthe processing of PDF417 labels read by a handheld scanner attached to
the auxiliary port.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
PDF 417 = Disable
PDF 417 = Enable
To Next Page
Loading...
