Datalogic Magellan 9300i - Databar Omnidirectional 2 D Component Enable

Enter/Exit Programming Mode
Product Reference Guide 335
DataBar Omnidirectional 2D Component Enable
When this feature is enabled, the software will not decode an DataBar Omnidi-
rectional bar code with a 2D component associated with it, and the 2D compo-
nent will be discarded.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
DataBar Omnidirectional 2D Component = Disable
DataBar Omnidirectional 2D Component = Enable
DEFAULT
04D600(CR)
04D601(CR)