Enter/Exit Programming Mode General Scanner and Scale Features
158 Magellan™ 9300i / 9400i Scanners
Scale Sentry Beep Enable
Enables/disables the beep indication for Scale Sentry.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Scale Sentry Beep = Disable
Scale Sentry Beep = Enable
To Next Page
Loading...
