Datalogic Magellan 9300i - MSI Minimum Read

Enter/Exit Programming Mode 1D Symbology Programming
408 Magellan™ 9300i / 9400i Scanners
MSI Minimum Read
This feature specifies the minimum number of consecutive MSI decodes before
is accepted as good read.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
MSI Minimum Read = 1
MSI Minimum Read = 2
MSI Minimum Read = 3
MSI Minimum Read = 4
DEFAULT
00BF01(CR)
00BF02(CR)
00BF03(CR)
00BF04(CR)