Enter/Exit Programming Mode 1D Symbology Programming
304 Magellan™ 9300i / 9400i Scanners
EAN-8 Guard Insertion
This setting enables the insertion of either a missing leading or trailing guard
to a scanned bar code.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
EAN-8 Guard Insertion = Disable
EAN-8 Guard Insertion = Enable
DEFAULT
To Next Page
Loading...
