Datalogic Magellan 9300i - Label Gone Timeout

Enter/Exit Programming Mode General Scanner and Scale Features
134 Magellan™ 9300i / 9400i Scanners
Label Gone Timeout
Specifies the amount of time in cycles (one cycle = 25ms) that data segments
are stored by the software before being discarded if a label has not been suc
-
cessfully decoded during the current “label in volume session,” which is defined
as the time between when the label gone time is first started until the label
gone timer expires.
To set the Label Gone Timeout:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes
on this and the facing page to ensure that the scanner reads
only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
This only applies to UPC/EAN labels when segment assembly
is enabled.
Label Gone Timeout = 0.4 Seconds
Label Gone Timeout = 0.6 Seconds
Label Gone Timeout = 0.8 Seconds
Label Gone Timeout = 1.2 Seconds
Label Gone Timeout = 1.6 Seconds
DEFAULT
004C10(CR)
004C18(CR)
004C20(CR)
004C30(CR)
004C40(CR)