Datalogic Magellan 9300i User Manual

Enter/Exit Programming Mode
Product Reference Guide 215
46XX Number of Host Resets
This setting specifies the number of consecutive resets before entering label
Programming Mode to allow scanner configuration.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, Set 46XX Number of Host Resets on page 215 below.
You’ll need to cover any unused bar codes on this and the facing page to
ensure that the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired number of resets. The selectable range is 01-15
data characters. Pad all single digit numbers with a leading zero to yield a
two-digit entry (01-15).
4. Scan the Enter/Exit Programming Mode bar code to exit Programming
Mode.
Set 46XX Number of Host Resets
Default setting for this feature is: 06 (six resets)
0330(CR)
DEFAULT

Datalogic Magellan 9300i Specifications

General

Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Standard interfaces	RS-232
Connectivity technology	Wired
Product color	Black, Grey
Built-in display	No
Sustainability certificates	RoHS

Weight and Dimensions

Weight	- g