Enter/Exit Programming Mode General Scanner and Scale Features
176 Magellan™ 9300i / 9400i Scanners
Remote Display — Enable/Disable
The scanning-scale can be configured to operate with or without a Remote Dis-
play.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
Recalibration/recertification may be required when adding a
Remote Display. Consult your local Weights and Measures
authority.
If this feature is enabled the scanner will expect that it is con-
nected to a Remote Display, and will indicate an error if one is
not. See
Error Codes on page 64 in the Problem Isolation on
page 63 section for more information.
Remote Display = Disable
Remote Display = Enable
To Next Page
Loading...
