Datalogic Magellan 9300i - USB Interface Selection

Enter/Exit Programming Mode Interface Related Features
208 Magellan™ 9300i / 9400i Scanners
USB Interface Selection
Remember to cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
CAUTION
Great care should be taken to select the correct interface type,
since you can cause damage to the scanner and/or POS termi
-
nal by attempting to change to an incompatible interface.
ALWAYS make interface selections with the host cable DIS
-
CONNECTED.
NOTE
Single cable installations require connection at the POS Termi-
nal (host) port. The Scale Host port connection is not used for
this interface.
Interface Type = USB OEM
Interface Type = USB TEC
Interface Type = USB COM
000145(CR)
00010D(CR)
000147(CR)