Datalogic Magellan 9300i - IBM Transmit Labels in Code 39 Format

Enter/Exit Programming Mode Interface Related Features
214 Magellan™ 9300i / 9400i Scanners
IBM Transmit Labels in Code 39 Format
This feature enables/disables scanner's ability to set a symbology identifier for
a specified label to Code 39 before transmitting that label data to an IBM host.
This applies to: Code 128, Code 93 and Codabar for IBM Port 5B; Code 93 and
Codabar for IBM Port 9B; Code 128, Code 93 and Codabar for OEM-USB.
To enable/disable the IBM Transmit Labels in Code 39 Format feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
When enabled, this feature has no effect on IBM
Port 17.
IBM Transmit Labels in Code 39 Format = Disable
IBM Transmit Labels in Code 39 Format = Enable
DEFAULT
027200(CR)
027201(CR)