Datalogic Magellan 9300i - Standard 2 of 5 Check Character Transmission

Enter/Exit Programming Mode 1D Symbology Programming
416 Magellan™ 9300i / 9400i Scanners
Standard 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Standard 2 of 5 check character.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
This feature applies only when Standard 2 of 5 Check
Character Calculation on page 415 is enabled. This item
is ignored when the advanced feature, Full Label Edit, is
enabled.
Standard 2 of 5 Check Character Transmission = Disable
Standard 2 of 5 Check Character Transmission = Enable
049B00(CR)
049B01(CR)
DEFAULT