Datalogic Magellan 9300i User Manual

Enter/Exit Programming Mode EAS Features
192 Magellan™ 9300i / 9400i Scanners
EAS Retry Count
This feature sets the number of times the deactivation sequence (defined by the
feature, “EAS Deactivation Duration — Retry ”) is restarted after a failed deacti
-
vation attempt.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, Set EAS Retry Count on page 192 below. You’ll need to
cover any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired number. The selectable range is 0-15 resets.
Pad all single and double digit numbers with leading zeroes to yield a two-
digit entry (00-15).
4. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
A setting of zero specifies no deactivation retries upon failed
deactivation attempt.
Set EAS Retry Count
Default setting for this feature is:
03 - Retry EAS Deactivation three times
0583(CR)
DEFAULT

Datalogic Magellan 9300i Specifications

General

Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Type	Built-in bar code reader
Sensor type	-
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Standard interfaces	RS-232
Connectivity technology	Wired
Product color	Black, Grey
Built-in display	No
Sustainability certificates	RoHS

Weight and Dimensions

Weight	- g