Datalogic Magellan 9300i - I 2 of 5 Check Character Transmission

Enter/Exit Programming Mode
Product Reference Guide 377
I 2 of 5 Check Character Transmission
Enables/disables transmission of an optional Interleaved 2 of 5 check charac-
ter.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
This feature applies only when I 2 of 5 Check Character Cal-
culation is enabled. This item is ignored when the
advanced feature, Full Label Edit, is enabled.
I 2 of 5 Check Character Transmission = Disable
I 2 of 5 Check Character Transmission = Enable
008B00(CR)
008B01(CR)
DEFAULT