Datalogic Magellan 9300i - Features; RS-232 Baud Rate

Enter/Exit Programming Mode
Product Reference Guide 221
RS-232 Features
RS-232 Baud Rate
This feature selects the baud rate required for sending and receiving data.
To specify the RS-232 Baud Rate:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the desired baud rate from the bar codes below and on the immedi-
ately following pages. You’ll need to cover any unused bar codes on this
and the facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
Single cable interfaces are limited to Baud Rate
selections up to 19200. They cannot communicate at
Baud Rates of 38400 and up.
RS-232 Baud Rate = 1200
RS-232 Baud Rate = 2400
RS-232 Baud Rate = 4800
RS-232 Baud Rate = 9600
RS-232 Baud Rate = 19200
001D04(CR)
001D03(CR)
001D02(CR)
001D01(CR)
DEFAULT
001D00(CR)