Datalogic Magellan 9300i - Codabar Start Stop Character Set

Enter/Exit Programming Mode 1D Symbology Programming
386 Magellan™ 9300i / 9400i Scanners
Codabar Start Stop Character Set
This feature specifies the format of transmitted Codabar start/stop characters.
Options are:
• ABCD/TN* E
• ABCD/ABCD
•abcd/tn* e
•abcd/abcd
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the bar code below or from the following page representing the
desired option. You’ll need to cover any unused bar codes and facing
pages to ensure that the scanner reads only the bar code you intend to
scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Codabar Start Stop Character Set = ABCD/TN* E
Codabar Start Stop Character Set = ABCD/ABCD
Codabar Start Stop Character Set = abcd/tn* e
Codabar Start Stop Character Set = abcd/abcd
022E00(CR)
022E01(CR)
022E02(CR)
022E03(CR)
DEFAULT