Enter/Exit Programming Mode 1D Symbology Programming
322 Magellan™ 9300i / 9400i Scanners
Enable EAN Two Label
Enables/disables the ability of the scanner to decode EAN two-label pairs.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
Contact Customer Support for details about advanced pro-
gramming for this feature.
EAN Two Label = Disable
EAN Two Label = Enable
DEFAULT
To Next Page
Loading...
