Datalogic Magellan 9300i - UPC-A Number System Character Transmission

Enter/Exit Programming Mode
Product Reference Guide 285
UPC-A Number System Character Transmission
Enables/disables transmission of a UPC-A number system character.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
NOTE
This feature MUST be enabled for IBM interfaces for proper
function.

This item is ignored when the advanced feature, Full Label
Edit, is enabled.
UPC-A Number System Character Transmission =
Disable
UPC-A Number System Character Transmission = Enable
00D300(CR)
00D301(CR)
DEFAULT