Enter/Exit Programming Mode
Product Reference Guide
341
DataBar Limited EAN128 Emulation Enable
Enables/disables GS1-EAN128 emulation for GS1 Databar Limited.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
Databar Limited EAN128 Emulation = disable
Databar Limited EAN128 Emulation = enable
DEFAULT
To Next Page
Loading...
