Enter/Exit Programming Mode
Product Reference Guide
247
Single Cable RS-232 Use BCC
Enables/disables the ability of the scanner to use BCC (Block Check Character).
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
Single Cable RS-232 Use BCC = Disable
Single Cable RS-232 Use BCC = Enable
DEFAULT
To Next Page
Loading...
