Datalogic Magellan 9300i - Databar Omnidirectional Double Read Timeout

Enter/Exit Programming Mode
Product Reference Guide 337
DataBar Omnidirectional Double Read Timeout
Specifies the minimum allowable time which must pass before reading the same
DataBar Omnidirectional label again (e.g. two identical items in succession).
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
Complete the programming sequence by scanning the Enter/Exit Programming
Mode bar code.
DataBar Omnidirectional Double Read
Timeout = 0.5 Seconds
DataBar Omnidirectional Double Read
Timeout = 1 Second
DataBar Omnidirectional Double Read
Timeout = 2.5 Seconds
DataBar Omnidirectional Double Read
Timeout = 3 Seconds
DataBar Omnidirectional Double Read
Timeout = 3.5 Seconds
00510A(CR)
005114(CR)
DEFAULT
005132(CR)
00513C(CR)
005146(CR)