Enter/Exit Programming Mode General Scanner and Scale Features
172 Magellan™ 9300i / 9400i Scanners
ICL Scale Interface DC1 Character Delay
When using the RS-232 ICL scale interface type, this option enables/disables
the ability of the scanner to delay DC1 response for 40 milliseconds.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
ICL Scale Interface DC1 Character Delay = Disable
ICL Scale Interface DC1 Character Delay = Enable
DEFAULT
To Next Page
Loading...
