Datalogic Magellan 9300i - 374; EAN-128 Enable

Enter/Exit Programming Mode 1D Symbology Programming
374 Magellan™ 9300i / 9400i Scanners
EAN-128
EAN-128 Enable
Enables/disables the ability of the scanner to translate EAN128 labels to the
EAN128 data format.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
EAN-128 = Transmit EAN128 labels in Code128 data format
EAN-128 = Transmit EAN128 labels in EAN128 data format
DEFAULT
02D800(CR)
02D801(CR)