Enter/Exit Programming Mode 2D Symbology Programming
426 Magellan™ 9300i / 9400i Scanners
Data Matrix Length 1, Length 2 Programming Instructions
If Data Matrix Length Control is set to Fixed-Length decoding, this feature
specifies Data Matrix first fixed length. If Data Matrix Length Control is set to
Variable-Length decoding, this feature specifies the minimum label length.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the bar code, Set Data Matrix Length 1 on page 426or Set Data Matrix
Length 2 on page 426 below. You’ll need to cover any unused bar codes
on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired label length. The selectable range for this
option is 0001 to 3116. Pad all numbers with leading zeros to yield a four-
digit entry (0001-3116).
4. Complete the programming sequence by scanning the ENTER/EXIT Pro-
gramming Mode bar code.
NOTE
For Data Matrix bar codes, only the data characters are
included in the length calculations.
Default setting for this feature = 0001
Set Data Matrix Length 1
Set Data Matrix Length 2
Default setting for this feature = 0320
To Next Page
Loading...
