Datalogic Magellan 9300i - Page 206

Enter/Exit Programming Mode EAS Features
194 Magellan™ 9300i / 9400i Scanners
EAS Exception Button (continued)
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar code.
EAS Exception Button = Disabled
EAS Exception Button = Enable Always
EAS Exception Button = Enable ONLY When Scanner
Enabled
058400(CR)
058401(CR)
DEFAULT
058402(CR)