Dodge Sprinter 2006 - Page 1015

(5) Remove the pin and the t wo turning loops fr om
the t urning loop bra cket .
(6) For a left ou tboar d seating posit ion only,
unsna p and remove t he plastic cover from the screw
that secures the rear seat belt lower anchor t o t he
left out board side of the seat fra me (Fig. 33).
(7) Remove the plastic shield from th e back of the
rear seat. (Refer to 23 - BODY/SEATS/REAR SEAT
BACK SHIELD - REMOVAL).
(8) Remove the screw t hat secur es the rear seat
belt lower anchor to th e rear seat cushion frame (Fig.
33) or (Fig. 34).
(9) Pull t he rea r sea t belt an d lower an chor
through the tu rning loop trim cover and the tur ning
loop bra cket .
(10) Remove th e screw that secures the rear seat
belt r etra ctor to th e bracket on t he rea r seat cush ion
frame (Fig. 35).
(11) Remove th e rea r seat belt a nd retr actor u nit
from the bracket on th e rear sea t cushion frame.
Fig. 32 Rear Seat Belt Turning Loop
1 - TURNING LOOP (2)
2 - PUSH NUT
3 - BRACKET
4 - PIN
5 - REAR SEAT BACK
6 - SEAT BELT
Fig. 33 Left Outboard Rear Seat Belt Lower Anchor
1 - REAR SEAT CUSHION TRIM
2 - REAR SEAT BACK TRIM
3 - SCREW AND COVER
4 - REAR SEAT BELT LOWER ANCHOR
Fig. 34 Right Outboard or Center Rear Seat Belt
Lower Anchor
1 - REAR SEAT CUSHION FRAME
2 - SCREW
3 - REAR SEAT BELT LOWER ANCHOR
Fig. 35 Rear Seat Belt Retractor
1 - RETRACTOR
2 - REAR SEAT CUSHION FRAME
3 - SCREW
VA RESTRAINTS 8O - 29