INSTALLATION
(1) In st all bumper step a nd install su ppor t bolts.
(2) Tighten bolts to 38 N·m (28 ft. lbs.).
(3) In st all frame bolt s/n uts a nd t ighten to 90 N·m
(66 ft. lbs.).
(4) In st all fascia. (Refer to 13 - FRAME &
BUMP ERS/BUMPERS/REAR FASCIA - INSTALLA-
TION )
REAR FASCI A
REMOVAL
(1) Remove screws a nd remove reflector s. (Fig. 4)
(2) Remove fascia bolts.
(3) Relea se bumper support brackets clips below
en d p a n el.
(4) Press dowel pins out of and remove four plastic
rivets conn ecting fa scia to r ear step, if equ ipped.
(5) Sepa rat e the cor ners of the fa scia fr om the su p-
por t brackets a nd rem ove fascia.
INSTALLATION
(1) In st all fa scia and seat t he corn ers over the sup-
por t brackets.
(2) Seat bumper support bracket s clips below end
pa nel firm ly.
(3) In st all the four plastic rivets to the bu mper
step, if equipped.
(4) In st all fa scia bolts and tighten to 23 N·m (17
ft. lbs.).
(5) In st all reflectors a nd reflector screws.
FRAM E
SPECI FI CAT I ON S
SPECIFICATIONS - FRAME DIMENSIONS
NOTE: Frame dimensions are listed in metric scale.
VEHICLE PREPARATION
Position the vehicle on a level work surface. Verti-
cal dimensions can be taken from the work su rface to
the locations in dicated were a pplicable.
Fig. 3 REAR BUMPER STEP
1 - FRAME BOLTS/NUTS (2)
2 - BOLTS (4)
3 - BUMPER STEP
4 - REAR FASCIA
Fig. 4 REAR FASCIA
1 - FASCIA
2 - BOLTS
3 - TAB
4 - REFLECTOR
5 - SUPPORT BRACKET
VA FRAME & BUMPERS 13 - 3
To Next Page
Loading...
