(3) Remove the cover panel from the top of t he
driver side seat r iser.
(4) Remove the fog la mp relay by graspin g it
firmly and pulling it straight out of the relay conn ec-
tor.
INSTALLATION
Fog lam ps ar e opt iona l equ ipment on th is model.
On veh icles equipped wit h fog lam ps, a fog la mp
rela y is loca ted in a dedicated connect or of the vehi-
cle wire harness. This connector is snapped into an
openin g in a stam ped sheet metal bracket which is
secured with screws within t he driver side fr ont seat
riser just ben eath t he seat r iser cover panel.
WARNING: To avoid personal injury or death, on
vehicles equipped with airbags, disable the supple-
mental restraint system before attempting any
steering wheel, steering column, airbag, seat belt
tensioner, or instrument panel component diagno-
sis or service. Disconnect and isolate the battery
negative (ground) cable, then wait two minutes for
the system capacitor to discharge before perform-
ing further diagnosis or service. This is the only
sure way to disable the supplemental restraint sys-
tem. Failure to take the proper precautions could
result in accidental airbag deployment.
(1) Position t he fog la mp relay to the relay conn ec-
tor.
(2) Align the fog lamp relay terminals with t he
term inal cavities in the relay connector.
(3) Usin g ha nd pressure, push firm ly a nd even ly
on the top of the fog lamp relay until the t erminals
are fully seated in th e relay connector.
(4) Position the cover pan el onto the top of th e
dr iver side seat riser (Fig. 15).
(5) In st all and t igh ten the two screws that secure
the cover panel to th e top of the seat r iser un der the
dr iver side front seat.
(6) Move th e dr iver side front sea t back to its driv-
ing position.
(7) Reconnect t he battery negative cable.
FOG LAM P SWI T CH
REMOVAL
WARNING: To avoid personal injury or death, on
vehicles equipped with airbags, disable the supple-
mental restraint system before attempting any
steering wheel, steering column, airbag, seat belt
tensioner, or instrument panel component diagno-
sis or service. Disconnect and isolate the battery
negative (ground) cable, then wait two minutes for
the system capacitor to discharge before perform-
ing further diagnosis or service. This is the only
sure way to disable the supplemental restraint sys-
tem. Failure to take the proper precautions could
result in accidental airbag deployment.
(1) Disconn ect and isolate the battery nega tive
cable.
(2) Remove the cluster bezel from t he in st rumen t
pa nel (Fig. 16). (Refer to 23 - BODY/INSTRUMENT
PANEL/CLUSTER BEZEL - RE MOVAL).
(3) From th e back of th e cluster bezel, squeeze the
two latches on the fog lamp swit ch body and push
the switch out thr ough the face of the bezel (Fig.
17).
Fig. 15 Seat Riser Cover
1 - DRIVER SEAT BACK
2 - COVER PANEL
3 - SCREW (2)
4 - SEAT RISER
Fig. 16 Fog Lamp Switch
1 - FOG LAMP SWITCH
2 - SCREW (2)
3 - CLUSTER BEZEL
4 - TO REAR WINDOW DEFOGGER SWITCH (OPTION AL)
5 - TO HEADLAMP LEVELING SWITCH
6 - TO FOG LAMP SWITCH (OPTIONAL)
8L - 12 LAMPS/LIGHTING - EXTERIOR VA
To Next Page
Loading...
