Symptom:
PAS SEN GER S EAT B ELT TENS ION ER CIRCU IT OP EN
Wh e n Mo n i to re d a n d S e t Co n d it i o n :
PAS S EN GER S EAT BELT TEN S ION ER CIR CU IT OP EN
Wh en Mon it ored: Wit h t h e ign it ion on , th e ACM m onit or s t h e r esist an ce of th e P a ssen ger
Sea t Belt Ten sion er cir cuit s.
Set Condit ion : When th e ACM det ect s an open cir cuit or h igh resist a n ce in th e P a ssen ger
Sea t Belt Ten sion er cir cuit s.
POSSIBLE CAUSES
PASSE NGE R SE AT BE LT TE NSIONER CIRCU IT OP EN
PASSE NGE R SE AT BE LT TE NSIONER LINE 1 OR LIN E 2 CIRCUIT OP EN
ACM, PASSE NGE R SE AT BE LT TE NSIONE R CIRCU IT OP EN
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE P RE SE NT
TE S T ACTION AP PLICAB ILITY
1 Tur n th e ign it ion on .
NOTE: Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
re fe rred to as a n ACM.
SE LE CT ACTIVE or STORE D DTC:
All
ACM - ACTIVE DTC
Go To 2
ACM - STORE D DTC
Go To 5
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 WA R N I N G : T O AV O I D P E R S O N A L I N J U R Y O R D E AT H , T U R N I G N I T I O N
OF F, D IS CON N ECT THE BATTERY AN D WAIT TWO MINU TE S B E FOR E
PROCEEDING.
Discon n ect t he P a ssen ger Sea t Belt Tension er con n ect or.
NOTE: Ch e c k c o n n e c to rs - Cle an an d re p a ir a s n e c e s s a ry.
Con n ect t h e appr opria t e Loa d Tool t o t h e Pa ssen ger Seat Belt Ten sion er conn ect or.
WA R N I N G : T O AV O I D P E R S O N A L I N J U R Y O R D E AT H , T U R N I G N I T I O N
ON , TH E N R E CON N ECT TH E B ATTE RY.
Wit h th e DRBIII", r ea d t he a ct ive Air ba g Con t r ol Module DTC’s.
Does t h e DRBIII" displa y PASSE NGE R SBT CIRCUIT OP E N?
All
Ye s → Go To 3
No → Repla ce t h e Pa ssen ger Sea t Belt Ten sion er in accor da n ce with t h e
Ser vice In for m a t ion .
Per for m AIRBAG VERIF ICATION TE ST - VER 1.
47
AI RBAG
To Next Page
Loading...
