REMOVAL - VACUUM TRANSDUCER
(1) Disconn ect the n egat ive battery cable.
(2) Remove the air cleaner housin g (Refer to 9 -
ENGINE/AIR INTAKE SYSTE M/AIR CLEANE R
HOUSING - RE MOVAL).
(3) Disconn ect the electrical conn ector.
(4) Disconn ect the vacuum hoses.
(5) Remove th e vacuum tr ansducer retainin g bolts
and rem ove vacuu m tran sducer.
INSTALLATION
INSTALLATION
(1) Clean all mat ing surfaces
(2) In st all tu rbocha rger to exha ust manifold.
Tighten bolts to 22 lbs. ft. (20 N·m) (Fig. 6).
NOTE: Slacken the bottom bolt of the turbocharger
support bracket to install bracket stress free.
(3) In st all tur bochar ger support br acket. Tight en
bolts t o 177 lbs. in. (20 N·m) at engine and 22 lbs. ft.
(30 N·m) at turboch arger (Fig. 6).
(4) Replace gaskets a nd inst all oil return line a t
turboch arger. Tigh ten bolt to 80 lbs. in. (9 N·m) (Fig.
6).
NOTE: Counterhold the connection at the turbo-
charger when tightening the oil supply line bolt.
(5) Replace gaskets and install oil supply line at
turboch arger. Tight en bolt t o 160 lbs. in . (18 N·m)
(Fig. 6).
(6) Attach turbocharger va cuum lin e to va cuum
unit (Fig. 6).
(7) Attach a ir in take and charge air hoses (Fig. 6).
(8) Connect front exhaust pipe to t urboch arger.
Tighten flange clamp to 22 lbs.ft . (30 N·m) (F ig. 6).
(9) In st all hea t shield (Fig. 6).
(10) Connect n egat ive batt ery cable.
Fig. 6 TURBOCHARGER
1 - TURBOCHARGER 8 - OIL RETURN LINE
2 - OIL SUPPLY LINE 9 - GASKET
3 - O-RING 10 - VACUUM UNIT
4 - FRONT EXHAUST PIPE 11 - CHARGE AIR HOSE
5 - BRACKET 12 - CLAMP
6 - O-RING 13 - AIR INTAKE HOSE
7 - GASKET 14 - HEAT SHIELD
11 - 8 EX H AU S T S Y S T EM VA
To Next Page
Loading...
