second time will t urn the hea ted sea t to Off. This
sa me pr ocess is r epeated for High heat setting. The
heat ed seat s will automa tically r etur n to the Off
mode anytime the vehicle ignition swit ch is tu rned
Off.
Both switches pr ovide sepa rate hard wire input s t o
the H eated Seat Relay to indicate the selected m ode.
The Hea ted Seat Relay responds to t he heated sea t
switch messages by controlling the ou tput t o the seat
heat er elem ents of t he selected sea t.
DIAGNOSIS AND TESTING - PASSENGER
HEATED SEAT SWITCH
For circu it descript ion and dia gra ms, refer to Wi r -
ing.
(1) In spect t he Heated Seat Swit ches for appar ent
da mage or stickin g/bin ding and r eplace if r equir ed.
Refer to Heated Sea t Switch Rem oval and Installa -
tion in this section .
(2) Replace the heated seat switch with a known
good unit and r etest the heat ed seat system .
REMOVAL
(1) Disconn ect and isolate the negat ive ba tter y
cable.
(2) Remove the gear selector bezel trim. Refer to
the Body section for the pr ocedure.
(3) Remove th e storage bin. Refer to the Body sec-
tion for th e procedur e.
(4) Remove th e swit ch bezel retaining screw a nd
remove the swit ch bezel from the instr umen t pan el.
Refer to t he Body section for t he procedu re.
(5) Disconn ect electrical conn ection s.
(6) Working from the underside of t he switch , gen-
tly r ock the swit ch back and forth out of it s mounting
locat ion in th e switch bezel.
INSTALLATION
(1) In st all the hea ted seat switch in its moun tin g
locat ion in th e switch bezel.
(2) Connect electrical connections.
(3) Position the switch bezel an d in st all the retain-
ing screw. Refer to the Body sect ion for th e proce-
dure.
(4) In st all the storage bin. Refer t o the Body sec-
tion for th e procedur e.
(5) In st all th e gea r selector bezel trim . Refer t o th e
Body section for the pr ocedure.
(6) Connect the n egat ive batt ery cable.
8G - 14 H EAT ED S EAT S VA
To Next Page
Loading...
Need help?
General
