(3) Pull the dome lamp/intr usion sensor unit from
its mountin g location far en ough to access an d dis-
connect the veh icle wir e harness from th e la mp con-
nector r eceptacle.
(4) Remove the dome lamp/intr usion sen sor u nit
from its mounting locat ion.
INSTALLATION
(1) Position t he dome lamp/intrusion sensor u nit to
its mounting locat ion (Fig. 8).
(2) Reconnect t he vehicle wire harn ess conn ector
to the dom e lamp/intr usion sensor un it connector
recepta cle.
(3) Position the edge of the dom e lam p/intrusion
sensor unit housin g opposite fr om the retainer clip
into the mounting hole.
(4) Push fir mly and evenly on th e notch ed edge of
the dome lamp/intr usion sensor unit housin g until
the r etainer clip la tches into place.
(5) Reconnect t he battery negative cable.
DOOR J AM B SWI T CH
REMOVAL
(1) Disconn ect and isolate the battery nega tive
cable.
(2) Open the door and rem ove the screw that
secures t he door jamb switch to the hinge pilla r of
the door open ing (Fig. 9).
(3) Pull the door jam b switch a way from the
mounting hole in the pillar far enou gh to access and
disconnect th e vehicle wir e h arness connector from
the back of the switch.
INSTALLATION
(1) Position th e door ja mb switch close enough to
the m ounting hole in th e hinge pillar of the door
openin g to reconnect the vehicle wire harness connec-
tor to t he back of the swit ch.
(2) Position the door jam b switch into th e m ount-
ing hole in th e hinge pillar (Fig. 9).
(3) In st all and tigh ten the screw that secur es th e
door jam b switch to the hin ge pilla r.
(4) Reconnect t he battery negative cable.
EN T RY / EX I T LAM P BU LB
REMOVAL
(1) Disconn ect and isolate the battery nega tive
cable.
(2) Remove t he ent ry/exit lam p unit from its
mounting loca tion . (Refer to 8 - ELECTRICAL/
LAMPS/LIGHTING - INTERIOR/ENTRY/EXIT
LAMP UNIT - REMOVAL).
(3) Grasp the la mp housing firmly in on e ha nd,
then rot ate th e bulb holder coun terclockwise and pu ll
it str aight out fr om the housing with the other han d
(Fig. 10).
Fig. 8 Dome Lamp/Intrusion Sensor Unit Remove/
Install
1 - NOTCH
2 - SENSOR (3)
3 - HOUSING
4 - SWITCH (2)
Fig. 9 Door Jamb Switch Remove/Install
1 - DOOR JAMB SWITCH
2 - PLUNGER
3 - PILLAR
4 - SCREW
8L - 34 LAMPS/LIGHTING - INTERIOR VA
To Next Page
Loading...
