Dodge Sprinter 2006 - Front Turn;Park;Side Marker Lamp Bulb Removal; Installation

(3) Pull the posit ion lamp bulb holder stra igh t ou t
to rem ove it from the front lam p unit r eflector (F ig.
23).
(4) Remove the posit ion la mp bulb fr om t he bulb
holder.
INSTALLATION
(1) In st all th e posit ion la mp bulb into the bu lb
holder (Fig. 23).
(2) Push the posit ion lamp bulb holder straight
into the mountin g hole in the front lamp un it reflec-
tor.
(3) Position the front la mp un it rear cover ont o the
lam p h ousing an d en gage th e retainers over ea ch
side of the cover t o secure it (Fig. 22).
(4) Reconnect t he battery negative cable.
FRON T T U RN / PARK / SI DE
MARKER LAMP BULB
REMOVAL
(1) Disconn ect and isolate the battery nega tive
cable.
(2) Locate th e tur n/park/side m arker bulb holder
on the rear outboard side of th e front la mp un it
housin g (Fig. 24).
(3) Rotat e the bulb holder coun terclockwise a bout
30 degr ees and pu ll it stra igh t ou t fr om t he lamp
housin g (Fig. 25).
Fig. 22 Front Lamp Unit Bulbs Remove/Install
1 - COVER RETAINER (2)
2 - BULB RETAINER (3)
3 - FOG LAMP BULB (OPTIONAL)
4 - COVER
5 - LOW BEAM BULB
6 - POSITION BULB
7 - HIGH BEAM BULB
8 - TURN/PARK/SIDE MARKER BULB
9 - FRONT LAMP UNIT
Fig. 23 Position Lamp Bulb Remove/Install
1 - BULB HOLDER
2 - LAMP REFLECTOR
Fig. 24 Front Lamp Unit Bulbs Remove/Install
1 - COVER RETAINER (2)
2 - BULB RETAINER (3)
3 - FOG LAMP BULB (OPTIONAL)
4 - COVER
5 - LOW BEAM BULB
6 - POSITION BULB
7 - HIGH BEAM BULB
8 - TURN/PARK/SIDE MARKER BULB
9 - FRONT LAMP UNIT
VA LAMPS/LIGHTING - EXTERIOR 8L - 15