INSTALLATION
(1) Clean all sealing surfa ces.
(2) In st all the engine oil cooler to th e timin g case
cover wit h a new ga sket. Tighten bolts t o 14N·m (124
lbs. in.) (Fig. 51).
(3) Reconnect the coolant hoses a nd tight en
clam ps.
(4) In st all new oil filter an d tight en oil filter cap to
25N·m ( 18 lbs. ft.) (F ig. 51).
(5) Refill cooling system.
(6) St art en gine and inspect for lea ks.
(7) Turn engine off an d ch eck engine oil level. Add
as necessa ry.
OI L FI LT ER
REMOVAL
(1) Unscr ew the oil filt er cap (Fig. 52)
(2) Remove clean a nd inspect cap gasket, replace
as necessa ry.
(3) Remove oil filter (Fig. 52).
INSTALLATION
(1) In spect oil filter cap gasket, if all r ight, lubr i-
cate with clean en gin e oil.
(2) In st all oil filt er.
(3) Scr ew oil filter cap to housing and tighten to
25N·m (18 lbs. ft.) (F ig. 52). Adjust oil level as n eces-
sary.
OI L J ET
DESCRIPTION
There are five oil jets installed in the engine block
(Fig. 53). These oil jets ar e used to cool an d lubr icat e
the piston assemblies.
Fig. 51 ENGINE OIL COOLER
1 - OIL FILTER
2 - OIL FILTER COVER
3 - GASKET
4 - BOLT
5 - COOLANT HOSE
6 - ENGINE OIL COOLER
Fig. 52 ENGINE OIL COOLER
1 - OIL FILTER
2 - OIL FILTER COVER
3 - GASKET
4 - BOLT
5 - COOLANT HOSE
6 - ENGINE OIL COOLER
VA ENGINE 9 - 57
To Next Page
Loading...
