(4) Pull the socket plat e a way fr om the in ner rear
pillar far enough to access the br ake/park lamp bulb
(Fig. 7).
(5) Remove th e brake/pa rk lamp bulb from th e ta il
lam p socket pla te.
INSTALLATION
(1) In st all the brake/pa rk la mp bulb into the ta il
lam p socket pla te (Fig. 7).
(2) Align the socket pla te with the moun tin g hole
in the inne r re ar p illar.
(3) Usin g han d pressure, push the socket plate
gent ly and even ly into th e inn er rear pillar mou nting
hole until bot h latch tabs ar e fully enga ged (Fig. 6).
(4) If t he vehicle is so equ ipped, reinstall th e trim
onto t he inside of the r ight or left rear corner pillar.
(5) Reconnect t he battery negative cable.
CEN T ER H I GH M OU N T ED
ST OP LAM P BU LB
REMOVAL
(1) Disconn ect and isolate the battery nega tive
cable.
(2) Remove the two screws that secure the
CHMSL lam p t o th e vehicle, then rem ove the len s
from the lamp housing (F ig. 8).
(3) Push straigh t in on the CH MSL bulb and
rotate i t counterclockwise about 30 degr ees to remove
it from th e lamp socket .
INSTALLATION
(1) In st all the CHMSL bulb into the lamp socket
(Fig. 8).
(2) Position the len s onto t he CH MSL lamp hou s-
ing
(3) In st all and t igh ten the two screws that secure
the CHMSL lam p t o the vehicle.
(4) Reconnect t he battery negative cable.
CEN T ER H I GH M OU N T ED
ST OP LAM P U N
REMOVAL
(1) Disconn ect and isolate the battery nega tive
cable.
(2) Remove the two screws that secure the
CHMSL unit to the veh icle (Fig. 9).
Fig. 6 Tail Lamp Socket Plate Remove/Install
1 - SOCKET PLATE
2 - INNER REAR PILLAR
3 - LATCH TAB (2)
Fig. 7 Tail Lamp Bulb Remove/Install
1 - BRAKE/PARK LAMP BULB
2 - BACKUP LAMP BULB
3 - TURN SIGNAL LAMP BULB
4 - SIDE MARKER LAMP BULB
5 - TAIL LAMP SOCKET PLATE
Fig. 8 CHMSL Bulb Remove/Install
1 - LAMP HOUSING
2 - BULB
8L - 8 LAMPS/LIGHTING - EXTERIOR VA
To Next Page
Loading...
