FRON T BU M PER - ST EPS
REMOVAL
(1) Remove fa scia. (Refer to 13 - F RAME &
BUMP ERS/BUMPERS/F RONT FASCIA -
REMOVAL)
(2) Remove the bolts a nd remove the steps. (Fig.
1)
INSTALLATION
(1) In st all step an d bolts.
(2) Tighten bolts to 20 N·m (15 ft. lbs.).
(3) In st all fascia. (Refer to 13 - FRAME &
BUMP ERS/BUMPERS/F RONT FASCIA - INSTAL-
LATION )
FRON T FASCI A
REMOVAL
(1) Remove the scr ews and cover. (F ig. 2)
(2) Remove push pin fast eners.
(3) Remove fascia scr ews.
(4) Pull bu mper forward off support br ackets.
(5) Disconn ect electrical conn ector.
INSTALLATION
(1) Connect outside tem perature sensor electr ical
connect or.
(2) Slide fa scia onto the su pport br ackets.
(3) In st all fascia screws a nd tight en to 23 N·m (17
ft. lbs.).
(4) In st all push pin fasteners.
(5) In st all cover a nd screws.
REAR BU M PER - ST EP
REMOVAL
(1) Remove rear fa scia. (Refer t o 13 - FRAME &
BUMP ERS/BUMPERS/REAR FASCIA - REMOVAL)
(2) Remove frame bolt s/n uts. (Fig. 3)
(3) Remove the rema ining su pport bolts.
Fig. 1 BUMPER STEPS
1 - BOLTS (2 PER STEP)
2 - STEPS
Fig. 2 FRONT FASCIA
1 - ELECTRICAL CONNECTOR
2 - OUTSIDE TEMPERATURE SENSOR
3 - FASCIA SUPPORT BRACKET
4 - FASCIA
5 - SCREWS (2)
6 - COVER
7 - PUSH PIN FASTENERS
13 - 2 F R AME & BU MP ER S VA
To Next Page
Loading...
