(18) Install ca liper s. (Refer to 5 - BRAKES/HY-
DRAULIC/MECHANICAL/DISC BRAKE CALIPERS
- INSTALLATION)
(19) Install new tie stra ps h olding wh eel speed
sensors a nd bra ke pa d wear sen sor s wire har ness to
cradle.
(20) Check and align vehicle t o specifications.
(Refer to 2 - SUSPENSION/WHE EL ALIGNME NT -
STANDARD PROCE DURE )
REAR CROSSM EM BER -
TRANSMISSION
REMOVAL
(1) Raise a nd support the vehicle. (Refer to
LUBRICATION & MAINTENANCE/HOISTING -
STANDARD PROCE DURE )
(2) Su pport transm ission with a suitable lifting
device.
(3) Remove the bolts/nuts and remove tra nsmis-
sion moun t cover. (Fig. 16)
(4) Remove crossmember nuts a nd crossmem ber.
INSTALLATION
(1) In st all crossmem ber and insta ll n uts.
(2) Tighten crossmember nut to 45 N·m (33 ft.
lbs.).
(3) Remove transmission support.
(4) In st all tra nsmission moun t bracket.
(5) In st all transm ission m ount bolts/nu ts a nd
tighten to 45 N·m (33 ft. lbs.).
TRAILER HITCH
REMOVAL
(1) Disconn ect and isolate battery negative ca ble.
(2) Raise a nd support the vehicle. (Refer to
LUBRICATION & MAINTENANCE/HOISTING -
STANDARD PROCE DURE )
(3) Disconn ect electrical conn ector. (F ig. 17)
Fig. 16 TRANSMISSION CROSSMEMBER
1 - TRANSMISSION MOUNT BOLTS (2)
2 - TRANSMISSION MOUNT COVER
3 - TRANSMISSION CROSSMEMBER NUTS (4)
4 - TRANSMISSION MOUNT NUTS (2)
5 - TRANSMISSION SUPPORT
6 - CROSSMEMBER
7 - TRANSMISSION MOUNT
VA FRAME & BUMPERS 13 - 11
To Next Page
Loading...
