(14) Remove rivet ing tool.
(15) Tur n over tool moving assem bly inser t to th e
riveting pr ofile.
NOTE: Rivet pins of the riveted link individually.
(16) Posit ion r ivet ing t ool exactly over m iddle of
pin (Fig. 65).
(17) Tighten riveting t ool spindle until it stops.
(18) Remove riveting t ool, in spect r iveting, re-rivet
if necessary (Fig. 66).
(19) Repeat procedu re for both r ivet s.
(20) Install oil pum p (Refer to 9 - ENGINE/LU-
BRICATION/OIL PUMP - INSTALLATION).
(21) Install oil pa n (Refer to 9 - ENGINE /LUBRI-
CATION/OIL PAN - INSTALLATION).
(22) Refill engine with pr oper oil to the correct
level (Refer t o LUBRICATION & MAINTE NANCE/
FLUID TYPES - SPE CIF ICATIONS).
(23) Connect n egat ive batt ery cable.
(24) Star t en gin e and inspect for leaks.
OI L SEN SOR
DESCRIPTION
Oil level, oil tempera ture and oil quality a re
detected by mea ns of an oil sensor located in the oil
pa n. The sen sor which oper ates on the ca pa citance
pr inciple features a n integrated electr onic cir cuit
which analyzes the th ree sign als. the signals are con-
st antly relayed to the ECM a nd over t he CAN bus t o
the instr umen t cluster by mea ns of PWM signal.
OPERATION
Oil qua lity is detected for indica ting t he need-
based oil change interva l. Th e oil qu ality is detected
on the basis of t he capa cita nce of t he engine oil
(dielectrics, does n ot conduct electr icity), t his being
as much as six t imes greater in case of poor qu ality.
Oil level and oil qu ality a re sepa rate of each other.
The in formation is first of all compen sa ted in th e
ECM before being tra nsmitted over the CAN bus.
Faults at th e oil sen sor a re detected by the ECM
and en tered into fault memory. The voltage for the
oil sen sor (a pprox.5V) is su pplied by the ECM.
Fig. 65 NEW LINK RIVETING
1 - SPECIAL TOOL #9312-5 INSERT
2 - SPECIAL TOOL #9312-1 RIVETING TOOL
3 - SPECIAL TOOL #9312-4 THRUST SPINDLE
4 - SPECIAL TOOL #9312-3 THRUST PIN
5 - SPECIAL TOOL #9312-12 INSERT
6 - OIL PUMP CHAIN
Fig. 66 RIVET INSPECTION
9 - 64 ENGINE VA
To Next Page
Loading...
