(6) Cut tie stra ps holding wheel speed sensor an d
brake pad wear sensor wire h arness to the cr adle.
(7) Cut tie straps holding tra nsmission ha rness to
the cr adle.
(8) Remove lower pinch bolt fr om steering shaft
and discon nect shaft. (Fig. 10)
(9) Siphon t he power steerin g fluid out of the res-
ervoir.
(10) Remove both the h igh pr essu re and return
hoses from the steer ing gear (Refer t o 19 - STEE R-
ING/PUMP/H OSES - REMOVAL) (F ig. 10).
(11) Remove bolt a nd remove power st eering h ose
su pport br acket from the cradle. (Fig. 11)
(12) Disconn ect brake lines from body side, at the
couplings. (F ig. 12)
(13) Support engine cra dle with su itable lift ing
device.
(14) Remove four cradle support bolts from ea ch
side of the cradle. (Fig. 13)
Fig. 9 FRONT DISC BRAKE CALIPER
1 - WEAR INDICATOR CABLE
2 - WEAR INDICATOR
3 - BOLT
4 - BRAKE HOSE
5 - DISC BRAKE CALIPER/ADAPTER
6 - ADAPTER BOLTS
Fig. 10 STEERING GEAR
1 - U-JOINT
2 - HIGH PRESSURE POWER STEERING HOSE
3 - RETURN HOSE
4 - OUTER TIE ROD END RETAINING NUT
5 - STEERING GEAR
6 - STEERING GEAR RETAINING BOLT
7 - STEERING GEAR NUT
8 - WASHER
9 - ENGINE MOUNT BOLT
10 - U-JOINT CLAMPING BOLT
Fig. 11 POWER STEERING HOSE BRACKET
1 - POWER STEERING LINE
2 - SUPPORT BRACKET BOLT
Fig. 12 BRAKE LINES
1 - BRAKE LINES
2 - LINE COUPLINGS
VA FRAME & BUMPERS 13 - 9
To Next Page
Loading...
