LEFT DOOR
(1) Remove door. (Refer t o 23 - BODY/DOORS -
REAR/DOOR - REMOVAL)
(2) Remove trim panel (20) (Fig. 5). (Refer to 23 -
BODY/DOORS - REAR/TRIM PANEL - REMOVAL)
(3) Disconn ect electr ical connectors and remove
license pla te lighting (18, 19).
(4) Pull out switch a nd disconnect electrical con-
nector (17).
(5) Remove and discard roll pin (12) an d rem ove
lock rod h andle (11).
(6) Remove door ch eck (23). (Refer t o 23 - BODY/
DOORS - RE AR/CHECK - REMOVAL)
(7) Remove door hinge (6). (Refer to 23 - BODY/
DOORS - RE AR/HINGE - REMOVAL)
(8) Remove closing wedge (4).
(9) Remove rivets (22) a nd r emove bottom closing
wedge (21).
(10) Remove rear door seal (8).
(11) Remove th e fou r screws (9, 14) fr om the lock
rod actuator.
(12) Using locking pliers, hold u pper lock rod (2)
and rem ove lock r od a ctuator.
(13) Remove clips (15).
(14) Pull out lock rod guides (1, 16) and rem ove
lock rods (2, 13).
Fig. 5 LEFT DOOR
1 - UPPER LOCK ROD GUIDE 15 - CLIPS (2)
2 - UPPER LOCK ROD 16 - BOTTOM LOCK ROD GUIDE
3 - LEFT REAR DOOR 17 - SWITCHES
4 - TOP CLOSING WEDGE 18 - ELECTRICAL CONNECTOR
5 - BOLTS (2) 19 - LICENSE PLATE LIGHTING
6 - HINGE 20 - TRIM PANEL
7 - BOLTS (2) 21 - BOTTOM CLOSING WEDGE
8 - REAR DOOR SEAL 22 - RIVETS (2)
9 - SCREWS (2) 23 - DOOR CHECK
10 - LOCK ROD ACTUATOR 24 - BOLTS (2)
11 - LOCK ROD HANDLE 25 - FELT STRIP
12 - ROLL PIN 26 - O-RINGS (2)
13 - BOTTOM LOCK ROD 27 - THREADED PLATE
14 - SCREWS (2)
23 - 26 D OOR S - R EAR VA
To Next Page
Loading...
