TE S T ACTION AP PLICAB ILITY
3 Tur n th e ign it ion off.
Discon n ect t he TCM ha r n ess con n ect or s.
Tur n th e ign it ion on .
Mea su r e a n d not e th e volt a ge of bot h CAN Bu s cir cu it at t h e TCM h a r n ess conn ect or.
NOTE: This code can be caused by an intermittent problem in the wiring
and connectors to the Transmission Control Module. Inspect the Transmis-
sion Control Module harness connector and associated wiring for signs of
poor terminal contact.
Is t h e volt a ge bet ween 2.2 volt s a n d 2.8 volt s for ea ch m ea su r em en t ?
All
Ye s → Test Com plete.
Per for m ROAD TE ST VE RIF ICATION - VER-2.
No → Repa ir th e CAN Bu s cir cu it (s) for a n open .
Per for m ROAD TE ST VE RIF ICATION - VER-2.
4 WARN IN G: WHEN THE E N GIN E IS OP ERATIN G, D O N OT STAN D IN A
DIR ECT LIN E WITH THE FAN . D O N OT P UT YOU R HAN D S NEAR THE
P ULLEYS , B ELTS OR FAN . D O NOT WEAR LOOS E CLOTHIN G.
NOTE: The conditions that set the DTC are not present at this time. The
fo ll o wi n g l is t ma y h e l p i n id en t i fy ing the i n t e rmi tt e nt c o nd i ti o n .
Wit h t h e en gin e r u n n in g a t n or m a l oper a t in g t em per a t u r e, m onit or t h e DRB
pa r a m et er s rela ted t o t h e DTC while wiggling th e wir ing ha r n ess. Look for pa r a m -
et er va lu es t o ch a n ge a n d/or a DTC to set .
Review t h e DTC Wh en Monit or ed a n d Set Con dit ion s. If possible, t r y to du plica t e t h e
condit ion s u n der wh ich t h e DTC wa s set .
Refer t o a n y Tech n ica l Service Bu llet in s (TSB) t h a t m a y a pply.
Visu a lly in spect t h e rela t ed wirin g h a r n ess. Look for a n y ch a fed, pier ced, pin ched, or
pa r t ia lly br oken wir es.
Visu a lly in spect t h e r ela t ed wir ing h a r n ess conn ect or s. Look for br oken , ben t , pu sh ed
out , or cor r oded t er m in a ls.
Wer e an y of t h e above condit ion s pr esen t ?
All
Ye s → Repa ir a s n ecessa ry.
Per for m ROAD TE ST VE RIF ICATION - VER-2.
No → Test Com plet e.
187
DRI V EABI LI T Y - DI ESEL
P 2211-ETC CAN MES S A GE MIS S IN G OR IN CORRECT — Co nt in ued
To Next Page