Need help?Do you have a question about the Dynex DSX and is the answer not in the manual?
General| Brand | Dynex |
|---|---|
| Model | DSX |
| Category | Laboratory Equipment |
| Language | English |
Identifies and illustrates the principal hardware components of the DSX™ Automated ELISA System.
Guides the user through establishing communication between the system and the personal computer.
Explains servicing of modular and non-modular components, including module replacement and on-site repairs.
Details the essential steps after service to ensure system functionality and component alignment.
Addresses failures occurring during system power-up, categorized into power-up and communication issues.
Describes issues where the instrument functions but not properly, focusing on communication and component faults.
Details how to select and perform various manual operations for different system modules.
Explains the design, command types, functional design, and hardware considerations of the X and Y drive mechanisms.
Details the Z-Drive, Pipette, and Load/Eject mechanisms, including their design, commands, and hardware.
Provides troubleshooting information for Pipette and XYZ Axis Assemblies, covering common symptoms and resolutions.
Details the procedure for field replacement of the Pipette Assembly, including cover removal and alignment.
Covers removal and replacement of Z-Drive components like motors, belts, encoders, and transition boards.
Explains the procedures for removing and replacing Y-Drive components such as belts, motors, and pulleys.
Details the replacement of X-Axis Drive components, including optointerrupters, motors, belts, and pulleys.
Provides a troubleshooting table for common issues like motor failure, sensor problems, and plate carrier movement.
Covers the replacement of internal components such as main circuit boards, heater assemblies, and sensors.
Details routine maintenance for the Reader Module, including lamp and filter replacement.
Provides troubleshooting guidance for error messages, general problems, and measurement errors in the reader module.
Covers the replacement of internal reader module components, including main boards, motors, and optical parts.
Details basic operations like initialization, purge, dispense, aspirate, soak, fill, bottom wash, sweep, move, terminate, and clean.
Provides troubleshooting for washer module issues, noting module replacement as standard response.
Covers internal component replacement, including bezel, rear cover, pinch valves, and circuit boards.
Details replacement of X/Z subassembly components: front panel, motors, belts, and microswitches.
Explains replacement of Y-Drive components: belts, moving base, sensor assemblies, bearings, motors, and pulleys.
Provides troubleshooting for the Ambient Drawer, covering symptoms like drawer movement and temperature errors.
Details servicing of internal components like drive mechanisms, motors, idlers, and circuit boards.
To Next Page
