Repairing/Replacing Internal Components
DSX™ System Service Manual 11-41
11.4.22 Separating the Upper Block Components
To Separate the Upper Block Components:
1 Unscrew the 6-M2 x 8mm button head screws holding the assembly together
(Figure 11-37).
Figure 11-37 Upper Block Components
2 Separate the lens strip
Note: Use care in handling or cleaning components. They are plastic and
very susceptible to scratches.
To Replace, Clean, and Reassemble Components:
1 Place the upper lens strip on the upper optics block.
2 Place the upper lens stop on top of the lens strip. Align all the parts by inserting
an AMFIX004 alignment dowel in the alignment hole and an AMFIX004 alignment
dowel in the alignment slot.
3 Fasten the assembly together using 6-M2 x 8mm button head screws and fasten
to module chassis using 2-M3 x 6mm socket head screws.
To Next Page
Loading...
