Dynex DSX - Chapter 18 Index

Jigs
DSX™ System Service Manual 18-1
motor, 15-8
features, 1-2
fan, 17-9
incubator module
main circuit board, 9-9
plate carrier motor, 9-17
position sensor, 9-14
testing, 5-5
top heater plate assembly, 9-11
lamp replacement, 11-1
Chapter 18 Index
advanced tests, 5-11
ambient drawer
accessing internal components, 15-3
electronics design, 14-1
microcomputer, 14-3
motor drivers, 14-3
overview, 14-1
servicing, 15-1
troubleshooting, 15-2
ambient drawer - removing and replacing
actuator levers, 15-13
drive belt, 15-4
idler subassemblies, 15-9
main circuit board, 15-10
optical sensors, 15-11
temperature sensor, 15-12
arm test, 5-9
aspirate pump
removing and replacing, 13-13
assays
loading, 2-8
barcode options, 15-17
setting, 15-17
cabling, 17-18
calibration, 3-10, 3-11
manual adjustment, 3-12
checking the system, 3-6
communication
initializing, 2-4
cover assembly, 16-1
removing and replacing, 16-3
removing and replacing rear cover, 16-2
removing and replacing top cover, 16-1
spare parts, 16-11
cycle test, 3-15
dispense bottle
removing and replacing, 13-7
dispense pump
calibrating, 13-9
removing and replacing, 13-8
verifying calibration, 13-10
drawer calibration, 3-11
drawer test, 5-4
DSX system
absorbance module, 1-11
ambient drawer, 1-5
analysis steps, 1-3
cleaning, 3-4
components, 1-4
cover, 1-12
covers, 16-1
functional description, 1-2
incubator modules, 1-7
installation, 2-1
maintenance, 3-2
manual operation, 5-1
module servicing, 3-5
overview, 1-1
pipette module, 1-6
software, 1-13
wash module, 1-8
work area, 1-4
electronics pod assembly (EPOD), 17-1
capacitor, 17-14
communications board, 17-12
components, 17-4
design, 17-3
fans, 17-1
inlet filter, 17-8
inlet switch, 17-6
overview, 17-1
power supply, 17-15
removal and replacement, 17-4
XY printed circuit board, 17-10
fans, 17-1
gas damping spring
removing and replacing, 16-9
hinges
removing and replacing, 16-10
components, 8-3
control of, 8-2
design, 8-1
drive belt, 9-15
eject sensor, 9-13
locking lever, pivot and spring, 9-23
operational activities, 8-4
overview, 8-1
plate carrier door, 9-6
removing external components, 9-3
spare parts, 9-26
troubleshooting, 9-1
interlock switch
removing and replacing, 16-8
Load Fluid wndow, 5-13