Replacing Components - Wash X/Z Subassembly
DSX™ System Service Manual 13-27
13.5.4 Replacing the X-Drive Microswitch
The X-Drive Microswitch is mounted on the left plate (Figure 13-17).
To Remove the Microswitch:
1 Remove the two M2 x 12mm Pozi Panhead screws, which mount the microswitch
to the plate.
2 Unsolder the two wires from the existing switch and re-solder them to the
replacement switch.
Note: When you reconnect the wires, use good soldering technique and
make certain that the junction is protected via shrink-wrap.
To Next Page
Loading...
